Argee TAR MSA-004-004 Manual de usuario descargar pdf (Pagina 38)

34 8e6 ThreaT analysis reporTer Quick sTarT Guide

Physically Connect the Unit to the Network

After performing initial setup procedures for the Threat Analysis Reporter, the unit should

be physically connected to the network. This step requires a standard CAT-5E cable to

connect the unit to the network. An additional CAT-5E cable is required if the Ethernet

Tap unit will be installed for bandwidth monitoring.

A. Plug one end of a standard CAT-5E cable into the Threat Analysis Reporter’s LAN 1

port, the port on the left.

Portion of chassis rear

B. Plug the other end of the CAT-5E cable into an open port on the network switch.

Bandwidth Management

If you choose to install the Ethernet Tap for bandwidth monitoring, you will need to con-

nect it to the Threat Analysis Reporter at this point. Refer to Appendix A at the end of this

document for instructions on how to connect the Ethernet Tap unit.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 58 59

Sin comentarios

Argee TAR MSA-004-004 Manual de usuario Pagina 38